Socket and transition pieces made of PE for PVC/CPE and copper gas pipes
This approval requirements describes the requirements for socket and transition pieces for making a non-end load connection with PVC/CPE pipes and PVC/CPE and copper pipes used with an operating pressure of up to 200 mbar. The diameter of the PVC/CPE pipe to be connected is ≤ 50 mm and the copper pipe ≤ 42 mm.
Receive a quote tailored to your needs
For who?
Manufacturers, grid companies, representatives, retailers, constructors and in installers.
Process steps
An approved quotation is the beginning of a tested and an approved product. You'll find the most important steps on the right. For more information you can contact our certification engineers.
Initial product assessment
The assessment to determine if all requirements in the approval requirement are met.
The result
The result is a certificate upon which is mentioned to which requirements the product complies.
Product verification
The assessment performed after granting certification to determine that the certified products still comply with the requirements in the approval requirement.
Control on quality system requirements
Control on following the IQC scheme (as described in the approval requirement) and the procedures.